18 Responses

1. I’ve read that Palladium foil filters Hydrogen molecules. So tiny, hydrogen can slip through the metal’s molecular matrix. I bought some years ago to hold, hoping to see it take off, but not yet. Maybe it never will. But I believe in Hydrogen fuels and fuel cell’s growth. Clean exhaust of H2O is the best. Your channel is fascinating and fun.

2. If you are trying to do some welding with HHO gas you are going to find hard to do. You have to add another gas to the HHO gas to perform the welding job or you are just cutting steel. I know for a fact because I added acetone flammable liquid gas so I would not heat the metal up to a crisp. I will have a new welding demonstration shortly using HHO gas and a flammable liquid gas to perform welding without cutting.

3. how many litres are you getting per minute

4. Its AMZAING what returning to SIMPLICITY brings, eh?

5. This is true! However, we can do the same thing by adding bottled oxygen to the mix, only for slag use. Torches are probably my favorite part of HHO technology…

6. if you use a pressurized tank to build up pressure and use the squeeze valve on the torch to increase gas pressure at the tip I wonder if you could make cutting even faster. the squeeze valve on the torch is used to blow away slag when using oxy-acetylene. I figure I higher volume of HHO gas out the torch tip would do the same if not slice through much thicker plates of steel.

7. yea you can weld steel to brick with HHO :D

8. stan meyer spoke of adding non combustible gases to reduce the burn rate and heat of the HHO to match other burning gases… i suppose that green hose could be used to supply CO2 or some other non combustible gas for different projects where not as much heat was required :)

9. Yes sir, it is HHO, 100% (well maybe a little steam). We used the hoses that came with the torch set up. The red one is hooked to a grey one, that’s hooked to my truck. The green hose is not hooked to anything, but could be used for additional oxygen.

10. That is Not HHO. it is oxyacetylene. Note the two hoses going into the torch at 25 seconds. One red & one green.

11. Well, I posted several videos about , but still none using Oxygen ..I guess will do it soon, you are right a video proof is required … .

12. Ok, then why isn`t so popular as oxi-fuel welding? I mean did you prove that equipment welding,not soldering or brazing,the steel pipe of the example stated before? Can you post any videos?thanks

13. HI ; You need to add Oxygen to weld steel , but you may can forget acetylene for ever with HHO , AND will use 1/2 the Oxygen for the same job , a win -win situation

14. can i use this great technology as substitute to oxyacetylene welding for example a simple motorbike trailer 2mm steel square pipe ?
    thanks

15. Cool, iam shure you will let us know =)

16. soon…very soon.

17. when are you gona mass produce those =)

18. how much do these cost?