This is NOT conspiracy theory, but actual unedited live video
from the TV news. See for yourself… and explain what caused
all the short but very bright flashes of light appearing around
the WTC tower buildings as they collapsed… give sensible
explanations for these very bright flashes of light, and for God’s
sake, don’t say it was from the jet fuel fire!!!
Watch these unedited close-up videos
of short but very bright flashes going off
before and during the collapses, and
not the horizontal explosions shooting
out of the buildings at floors well below
the collapsing levels (which are
supposedly “pancaking” into each other
above)…
Concrete cannot become pulverised
into fine dust without the aid of high
energy explosives! Strength = 27-42
MPa, or typically 4000 psi tensile
strength, stronger than most plastics!
Explain all the concrete powder and why
there were NO solid pancaked concrete floors
sitting one on top of each other at ground
zero. Nothing!
Here is the link:
http://www.youtube.com/watch?v=Qa7PN-8T2VY
Then watch 9/11 Mysteries and other
scientific documentaries at:
http://www.truth911.net
Look at the news videos too! Even
FOX News, ABC News, CNN reporters,
all reported explosions and bombs
going off before the Twin Towers
collapsed… even BBC reported that
WTC 7 already collapsed, even while
that building was still standing in the live
view behind the reporter’s head, and the
report of this collapse happened about
25 minutes BEFORE the building
collapsed – and WTC 7 was not even
hit by any plane!
http://www.prisonplanet.com/911.html
http://www.stj911.org
Please comment and be honest…
Leave politics and media stories out of
this discussion, and explain all the short
bright flashes:
http://www.youtube.com/watch?v=Qa7PN-8T2VY
You must face the truth and overcome
TV programmed prejudices, otherwise
you could be in a state of “denial” of
what really happened.
Think!!!
Some more engineering facts:
Melting point of steel = 1532 C
Temperature of a hydrocarbon fuel air
fire, whose only source of oxygen is from
still air = 233 – 250 C
Fahrenheit 451 = 451 F = 233 C, the
combustion temperature for paper fire.
Where did all the molten metal come
from, which was seen dripping out of the
South Tower, just before its collapse?
Watch the ABC News videos of the
liquid lava-life molten steel dripping out
of the South Tower… what made the
steel melt when it is a scientific fact that
air fires cannot melt steel? (Just like the
fuel-air combustions in your car’s engine
do not melt the pistons or the engine
block, made of cast or machine steel…
Why is it your steel cooking pots and
frying pans do not melt when exposed to
air fire? So what caused the molten
metal, as seen in these videos of the
WTC Twin Towers?
Molten metal videos:
http://www.youtube.com/results?search_query=molten+metal+wtc&search=Search
And one more question:
Why is it that controlled demolition
engineers and experts DO NOT USE
AIR FIRES TO DESTROY BUILDINGS?
It normally takes several days, usually
weeks (depending on the size of the
building) to set charges and explosives
and timers; and it would certainly cost
much more than simply pouring lots of
kerosene (jet fuel) on a few levels and
lighting it all up – to cause a free-fall
collapse after a 56 or 102 minute delay
period.
Why don’t demolition experts use fuel
air fires to completely demolish buildings
all the way right down to the ground?
Could it be, because air fires do not
weaken steel? Steel starts losing a little
bit of strength at 300 C, and drops down
to half its top strength at about 650 C,
so there is NO REASON for all the steel
of the WTC Towers to behave as weak
as air (to allow a freefall vertical collapse
into itself – the path of highest resistance
to falling).
Use a pyrometer to measure how hot
air fire is
