June 9, 2010 www.amazon.com Watch the full hearing: thefilmarchived.blogspot.com The first attempts to stop the oil spill were to use remotely operated underwater vehicles to close the blowout preventer valves on the well head; however, all these attempts failed. The second technique, placing a 125-tonne (280000 lb) containment dome (which had worked on leaks in shallower water) over the largest leak and piping the oil to a storage vessel on the surface, failed when gas leaking from the pipe combined with cold water formed methane hydrate crystals that blocked the opening at the top of the dome. Attempts to close the well by pumping heavy drilling fluids into the blowout preventer to restrict the flow of oil before sealing it permanently with cement (“top kill”) also failed. More successful was the process of positioning a riser insertion tube into the wide burst pipe. There was a stopper-like washer around the tube that plugs the end of the riser and diverts the flow into the insertion tube. The collected gas was flared and oil stored on the board of drillship Discoverer Enterprise. 924000 US gallons (22000 barrels) of oil was collected before removal of the tube. By June 3, BP removed the damaged riser from the top of the blowout preventer and covered the pipe by the cap which connected it to a riser. CEO of BP Tony Hayward stated that as a result of this process the amount captured was “probably the vast majority of the oil.” However, the FRTG member Ira Leifer said …
Video Rating: 0 / 5