Link to my FAQ Guide for 122333 www.ffxii.us First I’d like to mention that if you haven’t farmed Cerobi, since you opened up Balfonheim, make a priority of farming 3 of every shot. Most important would be these Windslicer, Mud, Wyrmfire, and Dark shot. Dark and Windslicer can take up alot of time but well worth the effort. Its more important to have 3 of every gun shots then having 1 ribbon. Plus the ribbon you can either find it in Henne Mines (higher %) or Pharos (100%). Roblon You’ll need 4 beserked players and 2 supporters. Make sure everyone wears Mirage Vest and Black Mask. (Drop from Banshees). Your first 2 besekers have them use Silent Shots. And your next 2 besekers a Silent and Aqua Shot (Roblon is weak vs Water). Supporters should have gambits as follows, plus their regular buffing gambits. Have gamits for Ally status blind = Eye Drops, Ally status poison = Antidote, Ally status confuse = Smelling Salts (just a precaution), Ally any = Esuna, and Ally hp 40% = X Potion Start heading up the hill, bring in 2 beserkers (both with silent shot), you’ll be constantly confronting Dead Bones on your way. But near the top look around because the instant you see no one else but Roblon, Put the 2 beserkers in reserve. Your now standing alone. Switch nihopalaoa and give Roblon a remedy but be quick, because Dead Bones will start spawning again. As soon as Roblon gets inflicted with the remedy (Slow, Oil and Sap) switch back your firefly and bring in 2 new beserkers this …
Video Rating: 4 / 5
CLICK “MORE INFO” FOR UPDATES Go to www.c3rider.com for more stuff about the C3 CHECK TEXT OF VIDEO 2 FOR MORE GREAT UPDATES! Edit may 29th: I tried derestricting with my new belt: Do not want. Yes, in ideal conditions (downhill or on very long flats), I can pin the needle all the way to the top (probably more than 70 km/h) but the acceleration and midrange power suffers greatly. It would slow down more when climbing hills, and wind have more effect on speed than when left restricted. Top speed restricted is now 65Km/h (halfway into the Yamaha logo). That is more than enough for an urbanite like me. I am not saying that you shouldn’t derestrict. Maybe it would be better for you than for me (mainly because I’m on the heavy side, I weight 215 lbs). So try it for yourself, and if you don’t like it, just revert. Also: by now, I think that three or four persons sent me private messages asking me how to re-tighten the belt after loosening it. (In part four, remember: spread the rear pulley halves to loosen the belt so that re-assembling the front pulley is easier). Once the front pulley is assembled, just start the engine. The belt will tighten itself almost immediately. Do this before replacing the trans cover to see for yourself. Also: Goldvisaguy, a member of the c3rider.com forums, got a brilliant idea for a tool to replace the strap wrench. It was quite cumbersome and frustrating to use a strap wrench to remove the front pulley, so Goldvisaguy invented a homemade tool that …
Video Rating: 4 / 5
